South Dade
Door Panel Replacement in Florida City
Panel replacement is for a skin that is gone, rusted through, or split, while the other sections stay straight. A closed dent, with the steel intact and the hinge line straight, is a different visit. The new panel has to match height, hinge pattern, and steel thickness. Color is matched at the opening, and faded paint will not blend invisibly with the old sections. People reach this page after a bumper hit or after the bottom skin turned soft.
Skin gone and the other sections straight
A hole, a split at a stile, or rust you can push through means that section is finished. The sections above and below can stay if their hinge lines are still straight. A dent that did not open the steel, and did not bow the stile, can be left. Water and sprinklers usually take the bottom section before the upper ones. Say which section, counting from the floor, and whether the damage is full width.
Match height, hinges, and thickness
Height is measured on the old section, because a mismatch shifts every hinge above it. The hinge hole pattern and the steel thickness have to match or the stack will rack. End hinges and roller carriers are checked, since a hit often bends them too. Never remove hardware, and never touch springs or cables to free a look at the damage. A photo of the whole door and of the bad section helps, and the tape confirms it.
A closed dent is a different visit
A shallow dent with a straight hinge line does not need a new panel. Paint over that dent is a choice, and it is separate from a rusted-through skin. If the dent pulled a hinge out of line, the panel may still be the repair. The visit decides from the stile and the hinge line, not from how large the mark looks. Creases that bow the section are panel work even when the steel is not open.
Color is judged at the opening
The new section is ordered in a color chosen while looking at the door in daylight. Faded paint on the old sections will not blend invisibly with that new piece. That color difference is expected, and it is mentioned at the measure. A full door is the path when several sections are faded and damaged together. One new panel in a straight door is still the right scope when only one section failed.
Rust along the bottom of older doors
A rusted panel on a smaller slab garage is often the one closest to the apron. Hot roofs do not punch the skin, but heat and damp age the older hardware above that panel. The tight grid has many original doors whose section height must be matched. US-1 traffic is nearby and does not supply that height or the hinge count. If the steel is soft only at the bottom, say so, and leave the springs alone.
Request this visit.
Call (645) 256-1794 about this door.
We answer any hour Sunday through Friday.
Saturday stays closed.
Keys Door Co is family-owned, local, and insured.
We have worked this coast for over ten years.
Common questions
Can one rusted garage door panel be replaced?
Yes, when the other sections are straight and the bad skin is gone, split, or rusted through. The new panel has to match the old height, the hinges, and the thickness. A twisted door or several ruined sections calls for a larger replacement.
Will the new panel match my faded door?
Color is chosen at the opening, and faded paint will not blend invisibly with the new section. The difference is normal on a door that has sat in the sun. Replacing every faded section is a different scope from one damaged panel.
Is a dent the same as a bad panel?
A closed dent with a straight hinge line can stay, and it does not need a new skin. A split, a hole, or a crease that bows the stile does. The hinge line, not the size of the mark, makes that call.
Place reference: City of Florida City
Request service
Name the street and whether the door is up, down, or stuck.
- Repairs and replacement parts
- Openers and controls
- New garage doors