South Dade
Door Panel Replacement in The Hammocks
Panel replacement is for steel that is gone, rusted through, or split on a single section. A dent that has not opened the face is a different visit. Straight sections stay on the door and set the pattern for the new skin. Height, hinge pattern, and thickness have to match or the joints above will miss. Daylight through the face, or a thumb that sinks into rust, marks the panel to order.
Skin that is actually gone
Replace the section when the steel is missing, rusted through, or split and the rest is straight. A closed dent stays off this order while the hinge line through it is still true. Water at the floor often takes the bottom panel and leaves the upper sections sound. A car strike is more likely to open a middle or upper skin instead. Count from the floor, and say whether the hole is a corner or the full width.
Checks before the section is ordered
With the door down, find the soft spot and see whether a thumb pushes through the rust. Look above and below that spot and confirm those hinge lines are still straight. A photo of a visible edge stamp is more useful than a guess at the size. Do not peel the skin, drill the face, or pull hinges to measure the damage. Never touch the springs, cables, or set screws while you are at the opening.
One panel, with the others staying
The new section matches height, hinges, and thickness of the straight panels that remain. A short piece shifts every hinge above it, so a near match is not enough to order. A closed dent belongs to another visit, and that line is drawn once on this repair. Springs can stay when the new skin weighs what the old panel weighed. A different build gets a balance check before the door goes back into daily use.
Color judged at the opening
Color is judged at this opening, in the light on this door, not from a chip alone. Faded paint on the older sections will not blend invisibly with a new skin. Say if the goal is simply closing the hole, because an exact blend is separate paint work. The new panel can stand out on a bleached face until the rest is painted. Doors along one row bleach at different rates, so a neighbor is a weak sample.
Hot roofs over two-car sections
The Hammocks repeats two-car sections, and one ruined panel does not mean the row shares that damage. Hot roofs bake the lower skin, so the bottom panel often fails while the upper ones hold. Busy cycles work a split wider once the steel has opened along a stile. The match comes from the straight sections on this door, not from the bay beside it. Should a gate control the block, leave the code off the form and give it by phone.
Request this visit.
Call (645) 256-1794 about this door.
We answer any hour Sunday through Friday.
Saturday stays closed.
Keys Door Co is family-owned, local, and insured.
We have worked this coast for over ten years.
Common questions
Can a closed dent stay off this order?
A dent stays off this order when the steel is closed and the hinge line is straight. Rust you can push through, or a split that opens the face, is the section to replace. Straight panels around that spot remain and set the match for the new skin.
Do the springs stay if only one panel changes?
Springs usually stay when the new panel weighs about what the old section weighed. A heavier build, such as an insulated face, is balanced before the door goes back to use. Mention that heavier face so the weight is part of the plan from the start.
Will the new panel match the faded paint?
Paint is compared at the opening, and a faded face will not look like a new skin. This order stops at a sound panel, and blending color is separate work. Doors on one row can bleach differently, so a neighbor's panel is a poor sample.
Place reference: U.S. Census Bureau census designated places
Request service
Name the street and whether the door is up, down, or stuck.
- Repairs and replacement parts
- Openers and controls
- New garage doors