South Dade
Door Panel Replacement in West Kendall
Panel replacement is for a section whose face is gone, rusted through, or split, when the other sections are still straight. People search it after a tear in the face, a hole you can see light through, or rust that has eaten one panel and left the rest. A closed dent, with the skin intact and the hinge line straight, is a different visit. Color is matched at the opening, and faded paint will not blend invisibly.
When the skin itself is finished
A section with the skin torn off or rusted into holes is no longer a paint or a dent visit. A split that opens farther each time the door moves will keep going until that section is changed. The sections above and below can stay if they are straight and the hinges still line up. A closed dent that did not break the skin and did not kink the hinge rail can remain.
Noting the bad section without pulling it
Count from the floor and name the damaged section, and look at whether its hinges are still in a straight row. Do not cut the damage back or bolt a plate over a hole, because that changes the thickness the new panel has to meet. Leave springs, cables, and set screws alone. Photos of the hole and of the full door in daylight show the color the new section has to sit beside.
Match height, hinges, and thickness
The visit measures section height, the hinge pattern, and the panel thickness before the replacement is ordered. The wrong height shifts every hinge above it and pulls the rollers against the track. Hinge grades change from the bottom of the door to the top, so the hardware has to land on the correct rail. Thickness has to meet the existing roller carriers. A straight neighbor section stays in place, and only the failed section comes off.
Color at the opening, and a dent that can stay
Color is compared outside at this opening, in the sun the door actually sees, rather than under a shop lamp. Faded paint on the older sections will show beside a fresh panel, and that difference is part of a one-section repair. A closed dent with an intact hinge line is left alone or handled as a smaller visit, not as a skin replacement. Insulation in the old section is noted, because a hollow replacement in an insulated stack changes the weight.
Sun-faded faces on a busy door
Newer two-car tract slabs carry wide sections that take west-facing sun every afternoon, and that sun is what fades the paint the new skin has to stand next to. High daily cycles flex a split until the skin opens across the panel. Heat does not pick the section height, but it does age the face that failed.
Request this visit.
Call (645) 256-1794 about this door.
We answer any hour Sunday through Friday.
Saturday stays closed.
Keys Door Co is family-owned, local, and insured.
We have worked this coast for over ten years.
Common questions
Can you replace one rusted garage door panel?
Yes, when the other sections are straight and the damage is one skin that is gone, split, or rusted through. The new panel has to match height, hinges, and thickness. A closed dent with a straight hinge line is a different visit and may not need a new section.
Will the new panel match the faded color?
Color is matched at the opening in the light the door actually gets. Older paint will look different beside a fresh section, and that is a normal result of replacing one panel. The match is as close as the available finish allows beside the older sections.
What if the new section is a different height?
Every hinge above it shifts, and the door can bind in the track. Height is taken from the sections that are staying. Thickness and the hinge pattern are measured in the same step so the rollers stay in line.
Request service
Name the street and whether the door is up, down, or stuck.
- Repairs and replacement parts
- Openers and controls
- New garage doors