Upper Keys
Door Panel Replacement in Tavernier
Panel replacement is for a section whose skin is gone, rusted through, or split, while the other sections stay straight. People search it after a hole in the bottom panel or a crack that opened along a stile. A closed dent, with the skin intact, is a different visit from a section change. The new section has to match height, hinges, and thickness before it is ordered. Color is matched at the opening, and faded paint will not blend invisibly with the old skins.
When the skin is gone
A hole through the face, rust that crumbles at the bottom channel, or a split stile is a panel job. The sections above and below can stay if their hinge line is still straight. A closed dent that did not break the skin is not this visit. The door can keep running with that dent until rust opens a hole. Matching the height matters, because the wrong panel shifts every hinge above it.
What you can check
Count the sections and see whether only one has a hole, rust-through, or a split. Look along the hinges and see if that row is straight. Do not unbolt the bad section while the springs are loaded. Never touch the springs, the cables, or the set screws. A photo of the damage and of the hinge number, if you can read it, helps the match.
Match height hinges thickness
The visit measures the bad section and matches height, hinge pattern, and steel thickness. A section that is tall or short moves every hinge location above that row. Rollers and hinges on that row are reused if they are straight, or replaced if they are bent. Balance is checked after the new skin is in, because the weight may differ. Color is chosen at the opening, and faded paint will not blend invisibly with a fresh panel.
A dent is a different visit
A closed dent with a straight hinge line can stay on the door. Paint cracks around a dent are watched until the skin actually opens. A sharp crease that kicks the stile out wears the roller and belongs in a section repair. Rust that is only on the surface is not the same as a panel that has rusted through. The order is placed from the measured height, not from a catalog photo alone.
Damp air and storms
The bottom panel on a basin lot in Tavernier rusts through sooner than the same panel on an inland lot. Humidity holds water in the bottom channel under the seal. Salt reaches that lowest skin sooner when the opening sits closer to the water. Storms can split a weak panel or drive rain into a hole that is already open. The repair is still one matched section when the rest of the door is straight.
Request this visit.
Call (645) 256-1794 about this door.
We answer any hour Sunday through Friday.
Saturday stays closed.
Keys Door Co is family-owned, local, and insured.
We have worked this coast for over ten years.
Common questions
Can you replace one rusted garage door panel?
One section with the skin gone or rusted through can be replaced when the others are straight. The new panel has to match the height, the hinges, and the thickness. The wrong height shifts every hinge above that row.
Will the new panel match my faded door?
Color is matched at the opening, and faded paint will not blend invisibly. The new section will be close, and the sun-faded panels around it will still look older. Height and hinge pattern matter more than a perfect color match.
Is a dent the same as a panel replacement?
A closed dent is a different visit from a skin that is split, holed, or rusted through. A straight hinge line means the dent can stay. A crease that bends the stile is the point where a new section is the repair.
Request service
Name the street and whether the door is up, down, or stuck.
- Repairs and replacement parts
- Openers and controls
- New garage doors