Upper Keys
Door Panel Replacement in Islamorada
Panel replacement is for a skin that is gone, rusted through, or split open. People search a hole in the steel, a crumbling bottom, and a split at a stile. The other sections should be straight, so this visit changes one panel only. Height, hinge pattern, and thickness have to match or the joints above the new panel shift. A closed dent is a different visit, and color is judged in the light at the opening.
Skin gone or split
Rust that has opened a hole, or a skin that flakes away, means that panel is finished. A split at a stile or a roller bracket leaves the section weak even if it still hangs. The panels above and below can be straight, which is what makes this a one-panel job. A closed dent with a true hinge line can stay as it is. Daylight through the steel, or a bottom edge you can push through, belongs in the description.
Photos and what not to pry
Photograph the bad section and count where it sits in the stack. Note the hinge size at that joint and whether a window or strut is on that panel. Never touch the springs, the cables, or the set screws to peel back flaking metal. Do not widen a rust hole, and do not cover it with tape as a patch. If the bottom fixture is pulling out of soft steel, park the door and keep people clear.
One panel or the whole door
The visit matches height, hinges, and thickness, then replaces the one failed section. Straight sections stay, and a closed dent with a true hinge line is left alone. If several panels are gone, or the door is twisted, a new door is the conversation. Rollers and the cable anchor on that section are moved onto the new, sound metal. The door is balanced once the new panel is in and the weight is checked.
Color height and hinges
Color is compared at the opening, because a new skin sits beside paint that has faded. Faded paint beside a new skin rarely blends out of sight, even in a matching color name. A window or a strut on the old panel is matched or moved onto the replacement. Hinge holes have to land on the new stile, or every joint above that panel shifts. Thickness that differs from the old skin changes the track gap and can cause a rub.
Bottom skins in open bays
The bottom panel on an open lower level takes salt air, wind, and storm splash at the sill. Houses along the highway and lots toward the basin often leave that edge outside. A skin rusted through at the bottom can be replaced while the upper sections stay straight. Color is still matched in the daylight at that opening, where the fade shows. Mention the open lower level so the visit inspects the sill under that panel.
Request this visit.
Call (645) 256-1794 about this door.
We answer any hour Sunday through Friday.
Saturday stays closed.
Keys Door Co is family-owned, local, and insured.
We have worked this coast for over ten years.
Common questions
Can one rusted garage door panel be replaced?
One panel with the skin gone or rusted through can be replaced when the others are straight. Height, hinges, and thickness are matched so the joints above that panel stay in line. Several failed sections, or a twisted stack, means the talk turns to a new door.
Is a dent the same as a ruined panel?
A closed dent with a straight hinge line can stay, and the skin is still holding. A hole, a split stile, or steel you can push through is the panel that gets replaced. Those two are separated at the opening before any section is ordered.
What has to match on a replacement panel?
The new section has to match the height, or the hinges above it sit out of line. Hinge pattern and skin thickness are matched at the same time as that height. A window or strut on the old panel is carried over when it belongs there.
Place reference: Village of Islamorada
Request service
Name the street and whether the door is up, down, or stuck.
- Repairs and replacement parts
- Openers and controls
- New garage doors