Upper Keys
Insulated Garage Doors in Tavernier
An insulated garage door carries a core between the skins, and that core adds weight. People search it when they want a new insulated door or when an opener strains on one they have. Insulation is not a wind rating for the opening, even when the door feels more solid. A kit glued to an old skin is not the same as a door built with a core. The opening is measured before anything is ordered, and the springs are matched to the finished weight.
Weight the springs must carry
A door built with a core weighs more than a hollow door of the same size. The springs have to match that weight, or the opener spends every cycle lifting alone. Sometimes the opener has to change too, if it cannot lift the heavier door smoothly. A glued foam kit on an old skin can also change the weight the old springs were built for. The difference shows up when the trolley is released and the door will not stay put.
What you can check
Read any label on the door for thickness, and feel whether the door is heavy by hand only if it stays. With the door down, you can see whether foam was glued on or the door has a factory edge. Do not cut into a section or pull on a spring to test the core. Never touch the springs, the cables, or the set screws. A photo of the door edge and of the opener cover helps show what is there now.
Core door or a glued kit
The visit tells a factory core from foam glued onto an old skin. A glued kit is not the same build as a door that was made with the core inside. If replacement is the path, the door is ordered with the core already in the sections. Springs are sized to that order, and the old opener is tested against the new weight. Measure width, height, headroom, and the jamb before the door is ordered.
Measure before the order
Width and height come from the opening, not from the old door if the jamb is out of square. Headroom decides whether a standard or a low-clearance track is required. Side room has to clear the track and the new end hardware. An opener that strains on the heavier door is replaced rather than turned up to hide the weight. The new door is balanced before it is run from the wall button.
Damp air and storms
A basin lot in Tavernier pits the hardware on a heavy insulated door sooner than an inland lot does. Humidity can sit against a glued kit and rust the old skin under the foam. Salt reaches hinges and rollers sooner when the opening sits closer to the water. Storms are a separate question from the core, which does not stand in for a tested wind assembly. The springs are still matched to the weight, whatever the weather does to the hardware.
Request this visit.
Call (645) 256-1794 about this door.
We answer any hour Sunday through Friday.
Saturday stays closed.
Keys Door Co is family-owned, local, and insured.
We have worked this coast for over ten years.
Common questions
Does insulation make a garage door wind rated?
The foam core changes weight and how the door feels, and the springs have to match that weight. A tested wind assembly is a different order from an insulated sectional door. The opening is measured before that heavier door is ordered.
Is foam glued to an old door the same as a core?
Glue on an old skin can change the balance and trap damp against steel that has started to pit. When a new door is the right path, it is ordered with the core already inside. The springs are then matched to that finished weight.
Will my opener lift an insulated door?
Sometimes the opener can lift the extra weight, and sometimes it needs to be changed. The door is weighed and balanced before that choice is made. Springs come before a larger motor on a door that is simply heavy.
Request service
Name the street and whether the door is up, down, or stuck.
- Repairs and replacement parts
- Openers and controls
- New garage doors