South Dade
Torsion Spring Repair in The Hammocks
Repeated two-car bays make one failed shaft look like a neighborhood pattern, and your header is still its own measurement. The torsion spring above the door is what stores the lift for that bay. Park the door after a header tick, a bang, a gap in a coil, or a sudden doubling of weight. Leave the set screws untouched, because they are holding the stored energy. Tract heat and the daily cycles are what finish coils on these bays. The section entrance places the stop, and any gate code stays off the form until we call.
Rows that repeat
From inside the bay, look at the header and leave the winding bars off the shaft. A gap in one coil, or a shaft that has shifted, is enough to describe from the floor. Photograph that header, and leave the set screws where they are because they hold the energy. The next house can share the elevation and still carry a different spring after a later door went in.
Same age, this shaft
Wire size, inside diameter, length, and wind have to fit this door and these drums. A wrong coil can make the door climb even when the bay looks like every other bay on the street. On a matched pair, both coils are usually renewed, since they share the daily cycles of a two-car opening. Bearings and cables are checked in that stop, and rollers are replaced only if they are flat or seized.
The code stays off the form
If a gate guards the section, keep the code off the form and give it when we call. The entrance name belongs in the message, because the rows repeat and a wrong turn loops through identical bays. Say if the door is the original leaf or a later replacement, when you know that history. That history can change the weight, and it does not change the rule about the set screws.
First line of the request
Put the section entrance in the first line with the symptom, then say whether the door is up or down. Add whether you see one coil or two, and whether it was a bang or a slow gain in weight. A header photo from the floor is welcome, and it should be this bay rather than the one beside it. Two-car openings look alike from the sidewalk and still diverge after one of them is replaced.
Heat over the bay
A door standing open should be described as open, with the section entrance so the row is right. A door that is down and heavy can wait for the return call. Leave the remaining coil unwound, and leave the button alone if the opener hums without moving the leaf. Heat in the roof explains tired springs, and it is no reason to loosen a set screw.
Request this visit.
Call (645) 256-1794 about this door.
We answer any hour Sunday through Friday.
Saturday stays closed.
Keys Door Co is family-owned, local, and insured.
We have worked this coast for over ten years.
Common questions
Why keep a gate code off the form?
The gate code is given when we call, not written on the form where it would sit with the request. The section entrance and the street go in the message, because repeated bays hide the right row. Tract heat does not change how the van gets through the gate.
Do these bays share one spring size?
Repeated bays look the same and still diverge after a replacement, so your shaft is measured. Wire, diameter, length, and wind have to match the drums on that shaft. A spring from the bay next door is not the order for this header.
Where should the section name go?
Put the entrance you use at the start of the message, then say whether the door is up or down. Add whether a coil has a gap, because a photo of this header helps the order. Keep the gate code off the form and share it only when we call.
Place reference: U.S. Census Bureau census designated places
Request service
Name the street and whether the door is up, down, or stuck.
- Repairs and replacement parts
- Openers and controls
- New garage doors