South Dade
Photo-Eye Repair in Naranja
Photo-eye repair covers a door that will not finish closing unless the wall button stays held. People also reach this job when the opener light blinks, or when the door reverses at the floor. A dirty lens, bad aim, sun on one eye, a nicked wire, or a box in the beam can cause it. Aim and the wire come before anyone orders a new pair. Holding the wall button is a one-time close, not a daily method.
Why the door will not close
A door that stops and reverses near the floor is often reacting to the eyes, not to the springs. If the close finishes only while a finger holds the wall button, the beam is the first suspect. A blinking opener light is the unit reporting that it does not trust the opening. Sun on one lens, a bracket knocked out of aim, or a staple through the low wire can look the same from the driveway.
Checks that stay on the eyes
Wipe each lens with a damp cloth, and see whether the small lights on the eyes change. Look along the brackets and confirm the two eyes point at each other. Move boxes, bikes, and bins out of the beam so the path across the opening is empty. Do not tape over the eyes and leave that tape in place for daily use. Never touch the springs, the cables, or the set screws while you clean a lens.
Aim, wire, then new eyes
The visit starts with aim, then the wire, and only then a new pair of eyes. A bracket that has slipped can be reset, and a clean lens can end the trouble without parts. A staple through the wire, or a break where the cable meets the opener, is a wiring repair. New eyes make sense when the housings are cracked, the lights are dead, or the wire and the aim are already sound. The down limit is checked when the reverse comes from door weight instead.
Sun, staples, and the beam
One eye facing a bright opening can wash out while the other eye still looks fine. The low wire is easy to nick with a staple when someone hangs a cord along the wall. A lens filmed with dust will blink the light even though the bracket has not moved. Alignment is a small adjustment, and it is different from replacing the logic board. The wall button override is there for a single careful close, with someone watching the opening.
Heat across ordinary sensors
Heat under older roofs leaves a film on ordinary photo eyes in these modest slab houses. Humidity keeps that film soft, so a wipe helps and the haze can return on a hot afternoon. Sun through the opening adds glare on the eye that faces the driveway. Side streets just off US-1 put many of these bays in the same bright, closed heat. Cleaning and aim still come before new eyes, because the warmth did not invent a different sensor.
Request this visit.
Call (645) 256-1794 about this door.
We answer any hour Sunday through Friday.
Saturday stays closed.
Keys Door Co is family-owned, local, and insured.
We have worked this coast for over ten years.
Common questions
Why hold the button to close?
The opener is allowing one close while it ignores the eyes, which is a bypass. That bypass is for a single careful close, with the opening kept clear. A daily habit of holding the button leaves the eyes out of the job.
Why does the door reverse right at the floor?
Reversing at the floor often means a broken beam, dirty lenses, or a down limit that is off. Sun on one eye can do the same thing in the afternoon. A wipe and a clear path are the useful checks before new parts.
Can I tape the photo eyes so the door will close?
Tape can force a close, and it also hides whatever is in the opening. Leaving the eyes taped turns off the guard the beam is meant to give. The visit restores aim or the wire so the eyes can guard the close again.
Request service
Name the street and whether the door is up, down, or stuck.
- Repairs and replacement parts
- Openers and controls
- New garage doors