South Dade
Photo-Eye Repair in Homestead
A Homestead slab door that closes only while the wall button stays held is a photo-eye problem. The sensors sit a few inches off the floor, where dust and irrigation mist reach them. They must see each other before a remote may finish the close on its own. Holding the wall button is constant pressure and can park the car with one careful cycle. That cycle gets the car in, and it is a poor way for the house to live every day.
What the open door shows
Open the door fully and stay on the concrete, where both eyes are visible without a ladder. Break the beam with a foot and see whether the lamp on each eye changes. Dust from the apron and irrigation mist both dull the line, and either one can stop a remote. Wipe the lens with a damp cloth, because a dry paper towel scratches the lens. A bin or a hose in the beam stops a close even when the brackets still look square.
Aim and the wire under the roof
The pair is aimed, power is confirmed, and the wire is traced before any eyes are replaced. A staple in the low run copies a dead sensor when you look at the door from the driveway. A nick beside a hinge does the same, and roof heat ages the jacket until that nick hides. A remote that lost its code is handled after the beam is known to be sound. The brand on the head matters because the sensor has to match that operator.
Dawn mist and afternoon sun
Irrigation at dawn leaves a film the afternoon sun then lights on an open slab. Say whether the miss lasts all day or shows only when the sun sits on the apron. A west-facing door shows that pattern more clearly than a bay tucked under a deep eave. Campbell Drive or Krome Avenue, with the cross street, is what names the apron.
Which control still closes
Try the wall button, the remote, and the keypad, and note which of them still close the door. A keypad that works while the remote stays silent points at the remote once the lenses are clear. Failure on all three, with only the held wall button succeeding, points at the beam. A reverse just above the floor can be the eyes, the down limit, or a bind at the slab.
Tape is not the repair
Tape over the eyes defeats the entrapment check, and the operator stops watching the opening. One held-button close can free a car, and after that the sensors need to work again. If the door is stuck open and the apron is in use, call (645) 256-1794 and say it is up. A door already down that only ignores the remote can wait on the form for a callback.
Request this visit.
Call (645) 256-1794 about this door.
We answer any hour Sunday through Friday.
Saturday stays closed.
Keys Door Co is family-owned, local, and insured.
We have worked this coast for over ten years.
Common questions
Why does the wall button close the door when the remote does not move it?
The held wall button is constant pressure, so one close can finish while the remote waits on the eyes. The sensors must see each other a few inches off the floor on this hot slab.
What does tape on the sensors leave this household without each ordinary evening?
Tape over the sensors defeats the entrapment check, and the operator no longer watches the opening. One held close can park a car, and the tape should be off before the next ordinary cycle.
Why does this door reverse before the bottom seal can meet the floor?
An early reverse on these slabs can be the eyes, the down limit, or a bind in the track. Afternoon sun on a filmed lens can look like a short limit from the apron.
Place reference: City of Homestead
Request service
Name the street and whether the door is up, down, or stuck.
- Repairs and replacement parts
- Openers and controls
- New garage doors