Lower Keys
Door Panel Replacement in Stock Island
Panel replacement is for a section whose skin is fully gone, rusted through, or split. The other sections stay true, and the hinge line above the damage is still usable. A closed dent with the steel intact is a different visit from a skin that is open. Height, hinge pattern, and thickness have to match or every hinge above the new piece shifts. Color is chosen at the opening, and faded paint does not blend invisibly with a new skin.
Skin gone or split
A hole in the lowest section is rust that started at the floor and ate through. A split from a bumper can open the steel while the sections above remain sound. If several sections are soft, the conversation turns instead toward a whole new door. A dent that did not break the steel, with a true hinge line, can stay as it is. Daylight through a panel means the steel is open, and that is a replacement of that section.
Leave the springs alone
Do not try to bend a split steel flat, and never touch the springs or cables. You can count how many sections are truly damaged and how many are still fully solid. A photo of the bad section beside a sound one shows the height that must be matched. Note the actual color in daylight at the opening, because a phone picture shifts the shade. Keep people clear if a sharp split edge sits where hands can safely pass it.
Match the other sections
We match the height, the hinge holes, and the thickness to the sections that remain. The wrong height moves every hinge above the new panel and lets rollers walk out. One ruined section on a true door is a panel order, and the other sections stay. Several ruined sections are the point when a full door replacement makes more sense. The door is run after the new skin is in, so the rollers are seen to stay in the track.
Color at the opening
Faded paint on the old sections does not blend invisibly with a brand new skin. The match is made at the opening, in the real light the door actually lives in. A closed dent is left alone when the hinge stile is true and the steel is intact. Thickness is checked because a thin skin on a thick stack changes how the hinges sit. Hinges from the old section are reused only when they are true and the holes agree.
Rust beside the yards
Older houses among the boatyards lose the lowest skin to salt spray beside a narrow spur. Some open bays keep that steel wet, so one section can rust through before the others. A split from a cart is a panel job, spray or no spray on the face. The measurements do not change with weather, and the spray explains why the bottom went soft. Mention an open bay so the lower edge is chosen for a floor that stays damp.
Request this visit.
Call (645) 256-1794 about this door.
We answer any hour Sunday through Friday.
Saturday stays closed.
Keys Door Co is family-owned, local, and insured.
We have worked this coast for over ten years.
Common questions
Can one rusted garage door panel be replaced?
One section with the skin gone can be replaced when the other sections are true. Height, hinges, and thickness must match or the stack above goes out of line. A closed dent with intact steel can stay and does not need replacement.
Will the new panel match the faded paint?
Old paint and new steel will show up in the daylight at the opening. The color is chosen while standing at the opening, not from a screen. The match is height and hardware, and the shade is as close as light allows.
When is a whole new door the better path?
Several sections that are rusted through or split are when a new door makes more sense. One bad section on a true door can remain a single panel replacement. The visit says which of those conditions is actually found in the opening.
Request service
Name the street and whether the door is up, down, or stuck.
- Repairs and replacement parts
- Openers and controls
- New garage doors